Removing The Rear Panel, High-Limit Thermostat, And Thermal Cutoff (Tco) (Gas Models Only) - Maytag MGD6500MBK Technical Manual

5. Remove the hex-head screw, unhook the other end of the thermal fuse
and exhaust thermistor then remove the component. See below figure.
REMOVING THE REAR PANEL, HIGH-LIMIT
THERMOSTAT, AND THERMAL CUTOFF (TCO)
(GAS MODELS ONLY)
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer.
3. Pull the dryer out from the wall so that you can access the rear panel.
4. To Remove the Rear Panel.
Ƀ Remove the seven 1/4" hex-head screws from the rear panel and
remove the panel.
FOR SERVICE TECHNICIAN'S USE ONLY
5. To remove the High-Limit Thermostat:
a. Remove the two wires from the thermostat terminals.
b. Remove the two hex-head screws and remove the high-limit
thermostat.
6. To remove the Thermal Cutoff (TCO):
a. Remove the two wires from the TCO terminals.
39