Dxlink Fiber Rx - Applying Power - AMX DXF-TX-MMD Instruction Manual

DXLink Fiber RX – Applying Power
Caution: The provided desktop power supply must be used to power the DXLink Fiber RX, and it must not
be altered in any way.
To apply power to the DXLink Fiber RX:
1.
Plug the cord from the desktop power supply (provided) into the power jack on rear of the DXLink Fiber RX
(2.1 mm DC jack for 12 V local power).
2.
Plug the desktop power supply into an AC external power source.
The Power LED on the front of the DXLink Fiber RX illuminates a constant green, which indicates a ready state.
Some LEDs turn a turn a constant color while some blink first. For normal LED display, see the table below.
DXLink Fiber Receivers – Indicator LEDs
The LED indicators are listed in the table as they appear on the front of the RX from left to right.
DXLink Fiber RX LEDs
Power
Video
Audio
Scaling:
– Bypass
– Auto
– Manual
IR TX
IR RX
Serial TX
Serial RX
NetLinx Link/Act
NetLinx Status
CEC
USB
* When the HDMI output cable is disconnected from the DXLink Fiber RX or if no EDID is found on the destination device,
the Auto LED is ON. In both cases, the DXLink Fiber RX will revert to a resolution of 1280x1024 @ 60 Hz until a different
EDID is detected.
DXLink Fiber Receivers – LED Troubleshooting
If the indicator LEDs for the units do not respond with a normal display as stated in the table on the previous page:
 
 
 
For information on restoring the unit's default settings on power up, see page 70.
Instruction Manual – DXLink Fiber Transmitters and Receivers
Normal Display
Green
Green
Green
One LED is green.
The other two are off.
Red
Yellow
Red
Yellow
Green
Green
OFF
Yellow
Check all power connections.
Check the "Detailed NetLinx (Link/Act and Status) LED Behavior" section on page 63.
Try the suggestions in the "Troubleshooting" chapter (page 97).
Indicates
Power is applied to the Receiver
A video signal is present through the Receiver
An embedded audio signal is present through the Receiver
Receiver is in one of the three modes for scaling
• At power up, the Receiver defaults to Auto Mode, unless a
different Scaling Mode has been persisted*
• Press the Scaling button to turn on Bypass or Manual
IR TX active communication
IR RX active communication
Serial TX active communication
Serial RX active communication
Active LAN connection to an AMX Network
LAN connection is active
CEC is not currently supported
USB port connection is established
Installation and Setup
55