AMX DXF-TX-MMD Instruction Manual page 109

Telnet Commands (continued)
FACTORYFWIMAGE
FWIMAGES
GET CONFIG
GET CONNECTION
GET DEVICE
Instruction Manual – DXLink Fiber Transmitters and Receivers
Resets unit to factory firmware image and parameters and reboots the DXLink Fiber unit.
Note: When a Transmitter is connected to a DXLink Fiber Input Board, the input board will
override the "ALL RESOLUTIONS" EDID and load the last stored EDID.
Displays firmware version information.
Displays the current connection settings.
Example:
>get config
Device number: 8010
Connection Settings
--------------------------------
Mode: NDP
System Number: 3155
Master IP/URL: 192.168.44.53
Master Port: 1319
Username:
Password:
IP Settings
--------------------------------
HostName: DXLF-TX-2075028
Type: DHCP
IP Address: 192.168.44.86
Subnet Mask: 255.255.255.0
Gateway IP: 192.168.44.2
MAC Address: 00:0f:3c:00:55:04
DHCP Server : 192.168.43.2
Lease Origin : THU 01/09/2031 12:59:02
Lease Duration : SUN 01/12/2031 12:59:02 (259200 sec)
Lease Renew (T1): SAT 01/11/2031 00:59:02 (129600 sec)
Lease Rebind (T2): SUN 01/12/2031 03:59:02 (226800 sec)
DNS Servers
--------------------------------
Domain suffix: amx.internal
Entry 1: 192.168.40.7
Entry 2: 192.168.40.8
Note: The system number and IP addressing information displayed is reflective of actual
operating values, not stored parameters.
Shows the Master connection information.
Example:
>get connection
Connection Settings
------------------------------
Mode: UDP URL
System Number: 1
Master IP/URL: 192.168.44.53
Master Port: 1319
Username:
Password:
Displays the device number.
Example:
>get device
Device Number
------------------------------------------
Stored Value:
Active Value:
Appendix B – Telnet (Terminal) Commands
0 (dynamic)
32005
109