AMX DXF-TX-MMD Instruction Manual page 112

Telnet Commands (continued)
SCALER
SEND_COMMAND
[D:P:S,"'command'"]
SEND_STRING
[D:P:S,"string"]
SET CONNECTION
Instruction Manual – DXLink Fiber Transmitters and Receivers
Note: This command applies only to the Receiver.
Shows video scaler status.
Example:
>scaler
--------------------------------
Scaler Input
Width
Height
VFreq
VIC
ZoomW
ZoomH
Interlace
Scaler Output
Width
Height
VFreq
VIC
ARWidth
ARHeight
Interlace
scalarMux
aspectRatio
pixelRep
imageFreeze
testPattern
DnSclHeight
DnSclWidth
UpSclHeight
UpSclWidth
VClipOffset
ClipHeight
ClipTopOff
VClipOffset
ClipWidth
ClipLeftOff
Sends the specified SEND_COMMAND (does not work with queries) to the current DXLink
Transmitter or Receiver.
Note: Commands cannot be forwarded to other D:P:S. Asynchronous notifications are
available for the Transmitters via Telnet (and NetLinx Studio).
Example:
send_command 6501:1:0,"'VIDIN_AUTO_SELECT-ENABLE'"
Sends the specified SEND_STRING to the current DXLink Transmitter or Receiver or
connected Master.
Note: Commands cannot be forwarded to other D:P:S. Asynchronous notifications are
available for the Transmitters via Telnet (and NetLinx Studio).
Example:
27,18,0"
send_string 32001:1:1,"
Sets the Master connection settings interactively, allowing the user to specify the mode
(for descriptions of various connection modes, see page 119).
• If the mode is TCP or UDP, the Master URL and port number can be specified as well.
• If Auto is selected, the System number can be specified.
• After all data is entered, if the parameters have changed, the DXLink Fiber unit will
disconnect from the Master, and begin trying to connect with the new settings.
Note: These changes do not require a reboot to take effect.
Appendix B – Telnet (Terminal) Commands
1920
1200
60
0
1920
1200
0
1280
1024
60
0
1280
800
0
1
0
1
0
0
800
1280
800
1280
0
1200
0
0
1920
0
112