AMX DXF-TX-MMD Instruction Manual page 117

Telnet Commands (continued)
SHOW TCP
SHOW UDP
SHOW XG STATS
TAIL
TIME
VERSION
Instruction Manual – DXLink Fiber Transmitters and Receivers
Shows the TCP list.
Example:
>show tcp Show TCP List
-------------
The following TCP connections exist(ed):
1: 192.168.43.57:23 <=> 192.168.43.51:51418 (connected)
2: Port:24 (listening)
3: Port:23 (listening)
4: Port:7 (listening)
Shows the UDP list.
Example:
>show udp Show UDP List
-------------
The following UDP ports are listening:
1: Port:1319
2: Port:68 (DHCP client)
3: Port:7
4: Port:2222
5: Port:4998
Note: This command applies only to the Transmitter.
Displays information about the XG connection.
Example (partial due to length of stats):
>show xg stats
**************** XG Block Information ****************
I2C 8-bit Address: 0x52
I2C 7-bit Address: 0x29
FW Version: 1.0.0.4
FW ID: 0x20A0
HW ID: 0x0000
Interface Version: 0x20
FPGA Version: 0x13
Build Date/Time: Feb 22 2014/13:56:06
Note: Direct use of this command applies only to the Transmitter. Using the TAIL command for
the Receiver requires superuser remote bug access.
Outputs the device log.
Displays the current time.
Displays the version information for the DXLink Fiber device.
Example:
>version
Device: DXF-TX-xxD
Serial: 1010560012345678
MAC Addr : 00:60:9f:9a:9d:35
Hardware : 0.2
DXLF Boot: v1.0.4
DXLF App : v1.2.6
DXLF Link: v1.0.1.2
Appendix B – Telnet (Terminal) Commands
117