AMX DXF-TX-MMD Instruction Manual page 111

Telnet Commands (continued)
GET USB
IP STATUS
LED [ON|OFF]
NDP UNBIND
OFF
ON
PING [ADDRESS]
PULSE
REBOOT
RENEW DHCP
RESET FACTORY
Instruction Manual – DXLink Fiber Transmitters and Receivers
Note: This command applies only to the Transmitter.
Displays USB statistics.
Example:
>get usb
USB Statistics :
Number of USB Connections
Number of Keyboard Messages
Number of Mouse Messages
Number of Table Messages
Number of Connections
Number of Disconnects
Number of Errors
Displays the IP status.
Example:
>ip status
NetLinx IP Connections
Connected to 192.168.43.52, port 1319
Enables/Disables LEDs for identification.
Clears the NDP binding to a Master (requires reboot to take effect).
Turns off the specified channel.
Turns on the specified channel.
Pings an address (IP or URL), to test network connectivity to and confirms the presence of
another networked device.
The syntax matches the PING application in Windows or Linux.
Example:
>ping 192.168.29.209
192.168.29.209 is alive.
Pulse specified [D:P:S], channel.
Reboots the DXLink Fiber unit.
Example:
>REBOOT
Rebooting...
Renews / Releases the current DHCP lease for the DXLink Fiber unit.
Note: Because sending this command can result in the unit acquiring a new DHCP address
and the functionality of the endpoints is dependent on the mated IP addresses of the TX (host)
and RX (device), the USB connection may need to be reestablished.
Example:
>RENEW DHCP
Resets the device's stored parameters to factory default state including removal of all security
settings, resetting to DHCP. This command will cause an automatic reboot.
Note: This command does not reset the device to the factory software image.
Note: When a Transmitter is connected to a DXLink Fiber Input Board, the input board will
override the "ALL RESOLUTIONS" EDID and load the last stored EDID.
Appendix B – Telnet (Terminal) Commands
: 0
: 0
: 0
: 0
: 0
: 1
: 0
111