Important Upgrade Information; Firmware Versions - AMX DXF-TX-MMD Instruction Manual

Important Upgrade Information

Caution: Upgrading the firmware is a serious action in that if the upgrade fails, it can leave the system
completely non-operational.
In the Event of Power Loss During an Upgrade
If power loss occurs before any firmware information has been transferred – when power is restored, the unit will remain
operational using the original firmware.
If power loss occurs after some of the firmware information has been transferred but before the transfer is complete –
when power is restored, the unit will time out and will not operate until a successful upgrade takes place.
Caution: If the application signals a failure, you must immediately reboot the Transmitter or Receiver and
attempt to upgrade the firmware again, as the unit is in an unknown state and cannot be guaranteed to be
operational.

Firmware Versions

The following tables contain firmware version information for the DXLink Fiber, Duplex and DXLink Fiber, Simplex
units.
DXLink Fiber Firmware Versions
Applies to
DXF-TX-MMD
DXF-TX-SMD
DXF-RX-MMD
DXF-RX-SMD
DXF-TX-MMD
DXF-TX-SMD
DXF-TX-MMS
DXF-TX-SMS
DXF-RX-MMD
DXF-RX-SMD
DXF-RX-MMS
DXF-RX-SMS
Note: For additional details on version differences, see the applicable Readme file.
Instruction Manual – DXLink Fiber Transmitters and Receivers
Version # Date
1.0.3 2/27/14 Baseline
1.0.1 2/27/14 Baseline
1.2.10 11/17/14 • Supports standalone (point-to-point) functionality
• Supports Simplex units and Unidirectional Mode for Duplex
units
1.2.1 11/17/14 • Supports standalone (point-to-point) functionality
• Supports Simplex units and Unidirectional Mode for Duplex
units
Appendix A – Upgrading the Firmware
Differences
102