AMX DXF-TX-MMD Instruction Manual page 126

7.
At the prompt (>), type SET DEVICE <num> and press Enter.


8.
At the prompt, type SET CONNECTION and press Enter.
9.
Specify TCP for the connection and the PC's static IP address for the Master.
The Transmitter or Receiver displays under the Virtual Master and is now ready for file transfers.
Note: The process can be repeated for additional Transmitters and Receivers.
File transfers via a Virtual Master:


Important: Once you have finished using the Virtual Master – if you disabled a network connection before
setting the PC's static IP address, be sure to disable the Virtual Master's network connection and enable the
original connection.
Instruction Manual – DXLink Fiber Transmitters and Receivers
For the <num> value, the valid range of device numbers is 0 to 31999.
Setting a device number does not require a reboot to take effect.
IRL file transfers, see page 72
Firmware file transfers, see page 100
Appendix C – Virtual NetLinx Master
126