Table of Contents
Advertisement
Understanding the printer menus
Use
Run Initial setup
Yes
No
Paper Sizes
US
Metric
Timeouts
Sleep Mode
Disabled
1–120 min
Timeouts
Print with Display Off
Allow printing with display off
Display on when printing
Timeouts
Hibernate Timeout
Disabled
1 hour
2 hours
3 hours
6 hours
1 day
2 days
3 days
1 week
2 weeks
1 month
To
Run the setup wizard.
Notes:
•
Yes is the factory default setting.
•
After completing the setup wizard by selecting Done at the
country or region selection screen, the default becomes No.
Specify the unit of measurement for paper sizes.
Notes:
•
US is the factory default setting.
•
The initial setting is determined by your country or region
selection in the initial setup wizard.
Set the amount of time the printer waits after a job is printed before
it goes into a reduced power state.
Notes:
•
30 min is the factory default setting.
•
Disabled appears only when Energy Conserve is set to Off.
•
The maximum amount of time is increased to 240 minutes
when Energy Conserve is set to Off.
•
Lower settings conserve more energy, but may require
longer warm‑up times.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm‑up time.
Print a job while the display is off.
Note: Display on when printing is the factory default setting.
Set the amount of time the printer waits before it enters Hibernate
mode.
Note: 3 days is the factory default setting.
69
Advertisement
Table of Contents
