Table of Contents
Advertisement
Additional printer setup
Warning—Potential Damage: Improper installation of the card may cause damage to the card and the
controller board.
Note: The entire length of the connector on the card must touch and be flushed against the controller board.
5
Close the controller board access door.
Note: When the printer software and any hardware options are installed, it may be necessary to manually add
the options in the printer driver to make them available for print jobs. For more information, see
available options in the print driver" on page
Installing hardware options
Installing optional trays
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
1
Turn off the printer using the power switch, and then unplug the power cord from the electrical outlet.
2
Unpack the tray, and then remove any packing material.
3
Remove the tray from the base.
4
Remove any packing material from inside the tray.
5
Insert the tray into the base.
20.
1
2
2
17
"Adding
Advertisement
Table of Contents
