Tips On Using Labels; Tips On Using Letterhead; Tips On Using Transparencies - Dell B2360d-dn User Manual

Laser printer
Hide thumbs Also See for B2360d-dn:
Table of Contents

Advertisement

Paper and specialty media guide

Tips on using labels

Print samples on the labels being considered for use before buying large quantities.
Note: Use only paper label sheets. Vinyl, pharmacy, and two‑sided labels are not supported.
When printing on labels:
Use labels designed specifically for laser printers. Check with the manufacturer or vendor to verify that:
The labels can withstand temperatures up to 240°C (464°F) without sealing, excessive curling, wrinkling, or
releasing hazardous emissions.
Label adhesives, face sheet (printable stock), and topcoats can withstand up to 172‑kPa (25‑psi) pressure without
delaminating, oozing around the edges, or releasing hazardous fumes.
Do not use labels with slick backing material.
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial sheets
also contaminate the printer and the cartridge with adhesive, and could void the printer and toner cartridge
warranties.
Do not use labels with exposed adhesive.
Do not print within 1 mm (0.04 inch) of the edge of the label, of the perforations, or between die‑cuts of the label.
Make sure the adhesive backing does not reach to the edge of the sheet. Zone coating of the adhesive should be
at least 1 mm (0.04 inch) away from edges. Adhesive material contaminates the printer and could void the warranty.
If zone coating of the adhesive is not possible, then remove a 2‑mm (0.08‑inch) strip on the leading and driver edge,
and then use a non‑oozing adhesive.
Portrait orientation is recommended, especially when printing bar codes.

Tips on using letterhead

Use letterhead designed specifically for laser printers.
Print samples on the letterhead being considered for use before buying large quantities.
Before loading letterhead, flex, fan, and straighten the stack to prevent sheets from sticking together.
Page orientation is important when printing on letterhead. For information on how to load letterhead, see:
"Loading trays" on page 27
"Loading the multipurpose feeder" on page 32

Tips on using transparencies

Print a test page on the transparencies being considered for use before buying large quantities.
Feed transparencies from the standard tray, or the multipurpose feeder.
Use transparencies designed specifically for laser printers. Transparencies must be able to withstand temperatures
up to 185°C (365°F) without melting, discoloring, offsetting, or releasing hazardous emissions.
Note: If the transparency weight is set to Heavy and the transparency texture is set to Rough in the Paper menu,
then transparencies can be printed at a temperature up to 195°C (383°F).
Avoid getting fingerprints on the transparencies to prevent print quality problems.
Before loading transparencies, flex, fan, and straighten the stack to prevent sheets from sticking together.
42

Advertisement

Table of Contents
loading

This manual is also suitable for:

B2360dB2360dn

Table of Contents