Control Timer Values (Sec) - Cisco SPA 525G2 Administration Manual

Configuring Regional Parameters and Supplementary Services

Control Timer Values (sec)

Control Timer Values (sec)
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide
• Segment 2: On=0.2s, Off=0.2s
• Segment 3: On=0.2s, Off=0.2s
• Segment 4: On=1.0s, Off=4.0s
• Total Ring Length=60s
The following table describes all control timer parameters. Each value is displayed
in seconds.
Field
Reorder Delay
Call Back Expires
Call Back Retry
Intvl
Call Back Delay
Interdigit Long
Timer
Description
Delay after far end hangs up before reorder tone is played. 0 =
plays immediately, inf = never plays. Range: 0–255 seconds.
Defaults to 5.
Expiration time in seconds of a call back activation. Range: 0–
65535 seconds.
Defaults to 1800.
Call back retry interval in seconds. Range: 0–255 seconds.
Defaults to 30.
Delay after receiving the first SIP 18x response before declaring
the remote end is ringing. If a busy response is received during
this time, the Cisco IP phone still considers the call as failed and
keeps on retrying.
Defaults to 0.5.
Long timeout between entering digits when dialing. The interdigit
timer values are used as defaults when dialing. The
Long Timer is used after any one digit, if all valid matching
sequences in the dial plan are incomplete as dialed. Range: 0–64
seconds.
Setting this value high can result in a longer post dialing delay
(PDD), which is the time between the start of a call and the time
the phone starts ringing. A value that is too low can result in dialed
digits not being correctly recognized.
Defaults to 10.
7
Interdigit
158