Control Timer Values (Sec) - Cisco IP Phone 6851 Administration Manual

Cisco IP Phone Web Page
Parameter
Cadence 6
Cadence 7
Cadence 8
Cadence 9

Control Timer Values (sec)

Parameter
Reorder Delay
Interdigit Long Timer
Interdigit Short Timer
Vertical Service Activation Codes
Parameter
Call Return Code
Blind Transfer
Code
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
174
Description
Cadence script for distinctive ring 6.
Defaults to 60(.2/.4,.2/.4,.2/4).
Cadence script for distinctive ring 7.
Defaults to 60(4.5/4).
Cadence script for distinctive ring 8.
Defaults to 60(0.25/9.75)
Cadence script for distinctive ring 9.
Defaults to 60(.4/.2,.4/2).
Description
Delay after far end hangs up before reorder (busy) tone is played. 0 =
plays immediately, inf = never plays. Range: 0–255 seconds. Set to 255
to return the phone immediately to on-hook status and to not play the
tone.
Long timeout between entering digits when dialing. The interdigit timer
values are used as defaults when dialing. The Interdigit_Long_Timer
is used after any one digit, if all valid matching sequences in the dial
plan are incomplete as dialed. Range: 0–64 seconds.
Default: 10
Short timeout between entering digits when dialing. The
Interdigit_Short_Timer is used after any one digit, if at least one
matching sequence is complete as dialed, but more dialed digits would
match other as yet incomplete sequences. Range: 0–64 seconds.
Default: 3
Description
This code calls the last caller.
Defaults to *69.
Begins a blind transfer of the current call to the extension specified after the activation
code.
Defaults to *88.