7.3.4.2
Removing a 3.5-inch HDD dummy module
Figure 93: Removing a 3.5-inch dummy module
Ê Press in on the locking tabs on both sides of the dummy module to
disengage the locking mechanism (1).
Ê While keeping the locking tabs pressed, pull the dummy module out of its
bay (2).
V
CAUTION!
Save the dummy module for future use.
Always replace dummy modules into unused HDD bays to comply
with applicable EMC regulations and satisfy cooling requirements.
TX2540 M1
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
169