Installing The Cmos Battery; Concluding Steps - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

System board and components

14.2.3 Installing the CMOS battery

Figure 255: Installing the CMOS battery
Ê At a slight angle, fit the new CMOS battery into its socket as shown (1).
V
CAUTION!
Ensure to insert the CMOS battery with the positive pole (label side)
facing up as shown (see close-up).
Ê Fold down the CMOS battery (2) until it locks in place.
Ê Ensure that the locking spring (3) is properly engaged.

14.2.4 Concluding steps

Ê Dispose of the CMOS battery in accordance with local regulations
concerning special waste.
"Reassembling" on page 62
Ê
"Connecting the server to the mains" on page 72
Ê
"Switching on the server" on page 73
Ê
Ê Verify whether the backup data on the Chassis ID EPROM has been
restored to the system board as described in section
information backup / restore" on page
"Verifying the system time settings" on page 98
Ê
344 Upgrade and Maintenance Manual
"Verifying system
87.
TX2540 M1