Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual page 389

Figure 293: Securing the accessible drive cage (B)
Ê Carefully turn the server upside down.
I
At least two people are needed to turn over a fully equipped server.
Remove hard disk drives and power supply modules in order to
facilitate the task.
Ê Secure the accessible drive cage with two screws.
I
Note the correct screw positions: The screw hole on the right that has
been used in the tower configuration remains empty.
Ê Install the front panel module as described in section
panel module" on page
Ê If applicable, install all accessible drives as described in section
an accessible drive" on page
Ê If applicable, install an HDD extension box as described in section
an HDD extension box" on page
Preparing the intrusion switch
Ê Remove the intrusion switch module as described in section
defective intrusion switch cable" on page
I
It is not necessary to disconnect the intrusion switch cable from the
system board.
Ê Attach a rubber bumper to the front intrusion switch and reinstall the
intrusion switch module as described in section
switch cable" on page
TX2540 M1
Converting a tower model to a rack model
338.
301.
183.
401.
Upgrade and Maintenance Manual
"Installing the new front
399.
"Installing the new intrusion
"Installing
"Installing
"Removing the
389