Performing A Raid Array Rebuild - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Basic software procedures
I
Administrator permission required: If you are prompted for an
administrator password or confirmation, type the password or
provide confirmation.
Ê To enable or resume a temporarily disabled or suspended BitLocker,
click Turn On BitLocker.
Ê Follow the instructions in the BitLocker Setup wizard.
I
For further information on how to enable or resume BitLocker drive
encryption, please refer to the Microsoft Knowledge Base.
Fujitsu service partners will find additional information (also available in
Japanese) on the Fujitsu Extranet web pages.

5.2.15 Performing a RAID array rebuild

After replacing a hard disk drive that has been combined into a RAID array,
RAID rebuild will be performed completely unattended as a background
process.
Ê Ensure that the RAID array rebuild has started normally. Wait until the
progress bar has reached at least one percent.
Ê Inform the customer about the remaining rebuild time, based on the
displayed duration estimate.
Figure 34: Progress bar (RAID array rebuild)
V
CAUTION!
The system is now operational, however, data redundancy will not be
available until the RAID array rebuild is complete. Depending on the hard
disk drive capacity the overall process can take up to several hours, in
some cases even days.
I
You may notice a slight performance impact during rebuild.
102 Upgrade and Maintenance Manual
TX2540 M1