Replacing An Fbu - Fujitsu PRIMERGY TX2540 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê If applicable, "Updating RAID controller firmware" on page 88
"Enabling SVOM boot watchdog functionality" on page 96
Ê
Note on BBU charging and calibration
The BBU may be deeply discharged due to extended storage time and wrongly
show as bad or defective in the ServerView RAID Manager.
In this case, the BBU will automatically enter a trickle charge cycle for recovery.
This initial charge may take up to 12 hours before the BBU will initiate a
recalibration cycle.
Ê Enter the ServerView RAID Manager and check the current BBU status.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide.
Ê If the BBU is shown as bad or defective, do not power off the server for at
least 12 hours to allow the charge and calibration cycles to finish.
Ê If the BBU status does not change after 12 hours, please try to initiate the
recalibration process manually using the ServerView RAID Manager.
I
If this procedure still does not fix the BBU status, please contact your
local Fujitsu customer service partner.
9.5.7

Replacing an FBU

Upgrade and Repair Unit
(URU)
Tools: tool-less
V
CAUTION!
Do not throw battery FBUs into the trash can. Batteries must be disposed
of in accordance with local regulations concerning special waste.
For further safety information, please refer to section
protection" on page
260
42.
Upgrade and Maintenance Manual
Hardware: 10 minutes
"Environmental
TX2540 M1