Table of Contents
Advertisement
Slim optical drive bezel blank
On some models, there is a bezel blank covering the slim optical drive bay. Remove the bezel blank before
installing an optical drive. To remove the bezel blank:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Press inward on the tab on the left side of the blank (1), and then rotate the blank off the front bezel (2).
NOTE:
After removing the slim optical drive bezel blank and installing a slim optical drive, you can install an
optional bezel trim piece (available from HP) that surrounds the front of the slim optical drive.
20
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
18).
(Front bezel on page
19).
17).
Advertisement
Table of Contents
