Table of Contents
Advertisement
Optical drive
NOTE:
You do not have to remove the front bezel to remove the optical drive.
The optical drive must be connected to the white primary SATA connector on the system board labeled SATA1.
CAUTION:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Disconnect the power cable and data cable (1) from the rear of the optical drive, push the green release
latch on the rear side of the drive toward the center of the drive (2), and then slide the drive forward and
out of the bay through the front bezel (3).
CAUTION:
damaging the cable.
16
Chapter 4 Removal and replacement procedures – small form factor (SFF) chassis
All removable media should be taken out of a drive before removing the drive from the computer.
(Access panel on page
When removing the cables, pull the tab or connector instead of the cable itself to avoid
(Preparation for disassembly on page
15).
14).
Advertisement
Table of Contents
