Bezel Blanks - HP Compaq Pro 4300 Maintenance And Service Manual

Bezel Blanks

Description
5.25-inch bezel blank
On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch external drive bays that
need to be removed before installing a drive. To remove a bezel blank:
1. Remove the access panel
2. Remove the front bezel
3. To remove a bezel blank, push the two retaining tabs that hold the bezel blank in place towards
the outer right edge of the bezel (1) and slide the bezel blank back and to the right to remove it
(2).
Figure 7-4
4. Replace the front bezel.
52 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Computer Access Panel on page
(Front Bezel on page
Removing a Bezel Blank
50).
51)..
Spare part number
570838-001