Installing A 5.25-Inch Or 3.5-Inch Drive Into A Drive Bay - HP 6200 Pro Microtower Series Hardware Reference Manual

Installing a 5.25-inch or 3.5-inch Drive into a Drive Bay

1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as compact discs or USB flash drives, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
5. Remove the computer access panel.
6. Remove the front bezel. If you are installing a drive in a bay covered by a bezel blank, remove
the bezel blank. See
7. Install four M3 metric guide screws in the lower holes on each side of the drive. HP has provided
eight extra M3 metric guide screws on the front of the chassis, under the front bezel. The M3
metric guide screws are black. Refer to
illustration of the extra M3 metric guide screws location.
NOTE:
the new one.
CAUTION:
internal components of the drive.
Figure 3-21
76 Chapter 3 Microtower (MT) Hardware Upgrades
Regardless of the power-on state, voltage is always present on the system board
Removing Bezel Blanks on page 61
When replacing the drive, transfer the four M3 metric guide screws from the old drive to
Use only 5-mm long screws as guide screws. Longer screws can damage the
Installing Guide Screws (Optical Drive Shown)
for more information.
Installing and Removing Drives on page 72 for an
ENWW