Table of Contents
Advertisement
Other Settings
Setting preroll time
Set the preroll time for preview or voice-over recording.
1
Press the MENU button, use the cursor buttons to
choose [SETTING] – [PREROLL TIME] and press
the SET button.
2
Select 3, 5 or 7 seconds for the preroll time.
Dividing the video of the event using text
memos
You can divide the video of an event, using text memos,
during event registration.
1
Press the MENU button, use the cursor buttons to
choose [SETTING] - [DIVIDED APPEND] and press
the SET button.
2
Select [ON] and press the SET button.
ON:
Divides the video of the event at the
text memo position.
OFF:
Does not divide the video of the event
at the text memo position.
Changing audio channel content
You can replace audio content that will become available
when creating events.
1
Press the MENU button, use the cursor buttons to
choose [SETTING] - [AUDIO CH] and press the SET
button.
2
Select the channels that will be switched.
Example: Select as shown below to switch CH1 and CH2
locations.
[AUDIO CH]-[CH1]=CH2
[CH2]=CH1
[CH3]=CH3
[CH4]=CH4
◆ NOTE:
• Press the MENU button, choose [SETTING] - [AUDIO CH] -
[RESET] to reset all audio channels to their defaults.
• The settings described here can also be used for switching
audio channel operations.
➝For details, refer to "Switching audio channels" (page
104).
Setting output for audio channels 5 - 8
Use the steps below to set output for audio channels 5 - 8 for
playback or Edit Copy of playlists.
1
Press the MENU button, use the cursor buttons to
choose [SETTING] - [AUDIO CH] and press the SET
button.
2
Select [CH5-8] and press the SET button to change
settings.
NONE:
Audio is not output via channels 5 - 8.
CH5-8:
Outputs audio for channels 5 - 8 of
video clips as audio channels 5 - 8.
Setting audio fade
Use setup menu No. 731 (PB FADE) to set up audio fade that
will become available when creating events.
Setting Auto Entry
When Auto Entry is enabled, after confirming edit using the
PREVIEW or REC button, the IN point of the recorder is
automatically set to the location after the last frame in the
edited section.
1
Press the MENU button and use the cursor buttons
to choose [SETTING] - [AUTO ENTRY].
2
Press the SET button, select [ON] and press the SET
button.
◆ NOTE:
• When all the following conditions apply, the time code of the IN
point for the recorder is displayed as "**:**:**:**."
- AUTO ENTRY is set to ON
- REPLACE TC is set to OFF
- Editing that includes the last frame of the recorder timeline is
performed
Editing: Preparing for Playlist Creation
93
Advertisement
Table of Contents
