Table of Contents
Advertisement
Display
No
Character code
17
INVALID AUDIO SIG
18
INVALID TC SIG
21
REC WARNING
CARD
26
ERROR<******>
41
LAN NO LINK
44
NET ERROR
49
LAN ERROR
50
BATTERY EMPTY
DIR NG
70
CARD<******>
RUNDOWN
71
CARD<******>
75
HDD INTERMITTENT
90
NOT 1× 100M SIG
91
COPY PROTECTED
92
1394 INITIAL ERROR Displayed when the 1394 interface connection is irregular.
93
INVALID TC MODE
INVALID EMBEDDED
95
TC
1
*
This warning appears only during recording. Then the audio is recorded mute.
2
*
This warning appears only during recording. The internally generated time code is recorded.
3
*
P2 card access from the network is not available in normal operating mode.
4
*
Operation continues but normal recording or playback may not be possible.
5
*
This warning appears at any time. This error disables input to the digital video interface.
6
*
"E-50" appears when the backup battery is depleted. Consult your supplier for information on a store that can provide you with a new battery
(CR2032 or the equivalent). Be sure to use setup menu No. 069 (CLOCK SET) to set the clock after battery replacement.
210
For Long and Trouble-Free Operation: Error Messages
Displayed when the audio data of a signal input from the 1394 interface is irregular.
Displayed when the time code data of a signal input from the 1394 interface is irregular. Operation
Displayed when a video or audio error occurs during recording.
To continue operation, turn the power off and then back on again.
Displayed when data was corrupted due to a P2 card error during recording.
This error is displayed after recording ends and remains on until the start of the next
operation.
Displayed when a load error occurs from a P2 card during playback.
(* indicates the slot number where the error occurred.)
Replace the P2 card in the slot where the error occurred.
Displayed in normal operating mode when there is a problem in the LAN connections.
Check the LAN connections.
The FTP server service is not started up in normal operating mode.
Check the network settings.
Displayed when a LAN connection or disconnection failed. Power off, then power up
again before use.
Should E-49 appear again, consult your supplier.
Displayed when a drop in the backup battery voltage for the internal clock is detected at
power on. Replace the internal battery.
The P2 card directory structure is not supported. (* indicates the slot number where the
error occurred.) Make a quick backup of card data and format the card.
The maximum number of overwrites has been exceeded. (* indicates the slot number
where the error occurred.) This P2 card should be replaced.
Displayed for 3 seconds when a dropout due to reduced hard disk performance occurs
during hard disk playback for monitoring purposes.
Use a faster hard disk.
Displayed when a signal input from the 1394 interface is not a DVCPRO HD (100 Mbps)
1× normal speed transfer signal.
Displayed when DV format recording is available and the copy guard signal input via the
1394 interface is in the copy inhibit mode.
23.98Hz
24Hz
59-23Hz
Appears during playback when the time code has been recorded in drop frame mode.
The video output is distorted and audio output is muted at the drop point of the time code.
Check the playback clip. Playing back a 24p frame-rate clip requires that the time code
be recorded in non-drop frame mode. Appears when the time code in an HD SDI input is
in the drop frame mode during EE or recording. Normal recording will not be possible
under these conditions. Check signal input to the unit. Set the input time code to non-drop
frame mode. (Appears when 23.98, 24, 59-23, 60-24 or 60-25 is set in setup menu No. 25
(SYSTEM FREQ).)
Displayed while synchronizing recorded video frames to the time code of a signal input
to the HD SDI connector when that time code is not advancing at 1× normal speed. (When
"SLTC" is selected in setup menu No. 032 (REC REF) or 29.97, 59-23, 60-24, 25 or 60-25
is selected in setup menu No. 25 (SYSTEM FREQ).)
Description
*
6
60-24Hz
60-25Hz
Deck operation
Operation
continues
continues
STOP
STOP
Operation
continues
Operation
continues
STOP
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Recording is
disabled
Recording is
disabled
5
*
Operation
only
continues
Operation
continues
*
1
*
2
*
3
4
*
Advertisement
Table of Contents
