Table of Contents
Advertisement
5
Use the audio fader control to adjust the level during
playback of audio level recording.
After ending or interrupting a playback of an audio level
recording, the audio level set so far is reflected and the
icon indicating that a level setting has been made appears
on the event on the timeline.
6
Check audio level by performing a review or playlist
playback
A review after setting the IN and OUT points in an event
and changing the audio recording level will play back the
event from start to end. To perform a playback check only
of the section where the audio recording level was
changed, press the SEEK TO IN POINT (IN + GOTO)
button and playback will start after locating the IN point.
◆ NOTE:
• Refer to the NOTE in "Changing Audio Level in an Event during
Event Registration" (page 114).
• This method for setting the audio level is not available for a hard
disk, an external device or an external input (live recording)
temporarily registered as a player.
Editing: Setting Audio Level
115
Advertisement
Table of Contents
