Time Code, User Bit And Ctl - Panasonic AJ-HPM200P Operation Instruction Manual

Time Code, User Bit and CTL

Time code
The time code is used when the time code signal generated
by the time code generator is to be recorded. The time code
values are indicated on the display and in the superimpose
display.
TCR 00: 07:
Hours Minutes Seconds Frames
User bit
User bit refers to the 32-bit (8 digits) data frame of the time
code signal made available to users. It allows you to record
operator numbers and other values. The alphanumeric
characters that can be used in the user bit are the figures from
0 - 9 and the letters A to F.
Setting the internal time code
4
OFF
METER
FULL/FINE
MONITOR
SELECT
METER SELECT
CH 1-4 CH 5-8
INPUT SELECT
VIDEO AUDIO
CH 1 CH 2 CH 3 CH 4
REC
VAR
UNITY
MARKER
THUMBNAIL PLAYLIST VIDEO A1
EDIT MODE A3
TRIM
SET LAST X
SLOT SELECT
MULTI DELETE
SEL IN ENTRY
EXIT MENU
CANCEL/PF DIAG
SLOT CLIP
CLIP LIST
OPERATION
PF1 PF2
1
Engage the stop mode.
2
Use the COUNTER button to select [TC].
04: 24
5 2 1
PREVIEW
STOP REC A.LEVEL REC
PLAYER
SOURCE SELECT STILL/
PLAY PAUSE REW FF
COUNTER
RESET
REVIEW
PREV NEXT
1 CLIP PLAY
NEW
TC PRESET
PROP
TEXT INT
TCG
MEMO
REGEN
PRESET
EXT
A2 GO TO
A4 A.DUB
MODE
OUT
ALL CLIP
SHIFT
PF3
PF4
3
Use the setup menu No. 504 (RUN MODE) to set the
run mode for the time code generator.
REC: The internal time code generator advances
during recording.
FREE: The internal time code generator advances
regardless of operating mode when the
power is on.
4
Set the TCG switch to PRESET mode.
INT-REGEN: This mode maintains the continuity with
the time code last recorded on a P2 card.
INT-PRESET: Starts recording from the value set with
the TC PRESET button.
EXT: Records according to external TC input.
5
Use the TC PRESET button to set the start value of
the time code or user bit.
1.
Press the TC PRESET button.
The left-most digit starts flashing.
2.
Press the up or down cursor button (▲/▼) or hold
down the STILL button and turn the search dial
to change the value.
3.
Press the left or right cursor button (b/a) or turn the
search dial to select digit to set.
The selected digits start flashing.
The setting ranges are as follows:
Time code:
User bit:
4.
Repeat steps 2 - 3 to change other values.
Pressing the RESET button resets the preset value to 0.
5.
When the start value is set, press the SET button.
The time code starts to advance when [FREE] is set in
step 3.
Setup: Time Code, User Bit and CTL
[59.94 Hz] [29.97 Hz]
00:00:00:00-23:59:59:29
[50 Hz] [25 Hz] [60-25 Hz]
00:00:00:00-23:59:59:24
[23.98 Hz] [24 Hz] [59-23 Hz]
[60-24 Hz]
00:00:00:00-23:59:59:23
00000000-FF FF FF FF
197