Table of Contents
Advertisement
Remote Operation of External Devices
Use the RS-422A or IEEE1394 interface to send commands to
an external device to control it.
The following functions permit remote control.
• PLAY, STOP, STILL, FF, REW, SHTL, JOG
• Counter and status LED indication
Setup Procedure
1
Press the PLAYER or SOURCE SELECT (SHIFT +
PLAYER) buttons.
• In the RS-422A interface, press the PLAYER button.
• In the IEEE1394 interface, press the SOURCE SELECT
(SHIFT + PLAYER) buttons.
OFF
METER
FULL/FINE
MONITOR
SELECT
METER SELECT
CH 1-4 CH 5-8
INPUT SELECT
VIDEO AUDIO
CH 1
CH 2
CH 3
CH 4
REC
VAR
UNITY
MARKER
THUMBNAIL
PLAYLIST
VIDEO
A1
EDIT MODE
A3
TRIM
SET
LAST X
MULTI
DELETE
SLOT SELECT
SEL
IN
ENTRY
MENU
EXIT
CANCEL/PF
DIAG
SLOT CLIP
CLIP LIST
OPERATION
PF1
PF2
• This allows the unit to perform remote control of external
devices.
◆ NOTE:
• Select 59.94, 50, 23.98, 24, 29.97 or 25 in setup menu No. 25
(SYSTEM FREQ) when using RS-422A.
• Select 59.94 or 50 in setup menu No. 25 (SYSTEM FREQ) when
using IEEE1394.
• Turn setup menu No. 27 (VDCP CMD) OFF to remote control the unit
from an external device.
• In AVC-Intra50 and AVC-Intra100 formats, IEEE1394 input and
output are not available.
• Complete any settings required for controlling a remotely connected
device before switching.
External Remote Control
1
PREVIEW
REC
STOP
A.LEVEL REC
PLAYER
SOURCE SELECT
STILL/
REW
FF
PLAY
PAUSE
COUNTER
RESET
REVIEW
PREV
NEXT
1 CLIP PLAY
NEW
TC PRESET
PROP
TEXT
INT
TCG
MEMO
REGEN
PRESET
EXT
A2
GO TO
A4
A.DUB
MODE
OUT
ALL CLIP
SHIFT
PF3
PF4
1
Indications during control of external
devices
In external control mode, the PLAYER lamp goes on and the
unit provides the following indications.
• The LED goes on to indicate external device status.
• Indicates the external device counter
• The unit is forcibly set to EE to enable reception of audio
and video from the external device
• Counter, status and P mark indications for the external
device are superimposed on the screen.
◆ NOTE:
When 1394 input is selected and the unit is in STILL mode, it goes into
EE mode after engaging STOP mode.
Remote operation procedure
The control buttons listed below enable remote control of an
external device.
STOP
Sends the STOP command.
PLAY
Sends the PLAY command.
STILL
Sends the STILL +0.0 command
REW
Sends the REW command.
FF
Sends the FF command.
Dial
Sends the SHTL or JOG command.
*
1
COUNTER
Sends the switch COUNTER command
(CTL/TC only).
1
*
RESET
Sends the 0 reset command in CTL mode.
*
1
Available only when using RS-422A
Connections: External Remote Control
135
Advertisement
Table of Contents
