Table of Contents
Advertisement
Side Panel
1.
SD/SDHC Memory Card Slot / Access Lamp
Insert an SD/SDHC memory card.
Insert the card with the label side facing up and the
end with the corner cut off facing in. Push in the card
until it locks into place. To remove the card, first make
sure that the lamp is lit in green or the lamp is not
blinking in orange, then push it in the direction of
insertion to release the lock.
➝For recording and playback of optional AVCHD,
refer to "Using SD/SDHC Memory Cards" (page 74).
◆ NOTE:
<Precautions in using SD/SDHC memory cards>
• Do not insert any cards other than SD/SDHC memory
cards.
• This unit uses only SD/SDHC memory cards that comply
with the SD/SDHC specifications. Other memory cards
such as MultiMediaCard cannot be used. When using a
miniSD memory card, be sure to use an adaptor dedicated
for use with the miniSD memory card to insert the card into
the SD Memory Card Slot.
- MultiMediaCard (MMC) is a registered trademark of
Infineon Technologies AG.
- The SDHC (SD High Capacity) card is a new standard,
established by the SD Card Association in 2006, for
large-scale memory cards with capacities above 2 GB.
• Cards that will be used on this unit should also be formatted
on this unit.
• This unit supports the following SD and SDHC memory
card capacities.
SD: 8 MB to 2 GB
SDHC: 4 GB to 32 GB
• For the latest information not available in the Operating
Instructions, visit the P2 support desk at the following Web
sites.
For English: http://pro-av.panasonic.net/
• For details on recording and playing back optional AVCHD,
refer to "Using an Optional AVCHD Board" (page 151).
eSATA
1
2
DEVICE
U
HOST
L
S
A
B
N
2.0
3
4
5
2.
eSATA connector
Enables connection of a hard disk drive with an eSATA
connector using the unit as host device.
➝Refer to "Using This Unit With a Hard Disk" (page
124).
3.
USB 2.0 HOST connector (Type A)
Enables connection of a variety of devices using the
unit as a USB host.
P2 store and other USB 2.0 compatible hard disks can
be connected.
➝Refer to "Using This Unit With a Hard Disk" (page
124).
4.
USB 2.0 DEVICE connector (Type B)
Connect personal computers and other devices for
use in the USB device mode.
➝Refer to "Using USB or eSATA Connectors" (page
122).
◆ NOTE:
• Use double shielded cable for making connections to USB
2.0 connectors.
5.
LAN connector
Connect to a 1000base-T, 100base-TX or 10base-T
network.
➝Refer to "Connecting This Unit to a Network" (page
137).
◆ NOTE:
• Use a shielded cable to connect to the LAN connector.
Introduction: Control Reference Guide
33
Advertisement
Table of Contents
