Table of Contents
Advertisement
◆ NOTE:
• For the latest information not available in the Operating Instructions,
visit the Support Desk at the following Web site.
For English: http://pro-av.panasonic.net/
• This unit supports SD memory cards formatted using the FAT12 and
FAT 16 format compatible with the SD standard and SDHC memory
cards formatted using the FAT 32 format.
• This unit supports 4 GB or larger memory cards only if they are
SDHC memory cards.
Cards that are 4 GB or larger without an SDHC logo do not conform
to the SD standard.
• Format SD memory cards on this unit. SD memory cards formatted
on a computer or other device may delay start of recording or may
not be used in this unit.
➝ Refer to "Formatting SD Memory Cards" (page 74).
• MultiMediaCards cannot be used.
SD memory card slots and access lamps
Clips recorded on SD memory cards inserted in the SD/SDHC
memory card slot on the AJ-HPM200 can be played back as
thumbnails and video clips corded on P2 cards.
■ Access lamps
Steady orange light:
Flashing orange light
(fast):
Flashing orange light
(slow):
Off:
SD memory card protection
Set the write-protect switch to [LOCK] to prevent accidental
deletion of data recorded on an SD card.
Write-protect switch
152
AVCHD Recording and Playback: Using an Optional AVCHD Board
Card is available for reading and
writing.
Recognition phase to determine
whether the card is defective or not
Card is being accessed.
Card is not available for reading and
writing.
No card is inserted, the card has not
been formatted or a non-compatible
card has been inserted.
Write protect status, no free space
left on card
Formatting SD memory cards
Use the thumbnail menu to format SD memory cards.
➝Refer to "Using SD/SDHC Memory Cards" (page 74).
You can also use the menu in the AVCHD mode for formatting
SD memory cards.
➝For how to switch to the AVCHD mode, refer to "Switching
to AVCHD mode" (page 155).
1
Switch to the AVCHD mode and press the MENU
button.
2
Select [CARD FUNCTIONS] – [CARD FORMAT] and
press the SET button.
Select [YES] in the screen shown below that appears. To
cancel formatting, select [NO].
3
Select [YES] in the confirmation dialog.
The SD memory card will now be formatted.
4
Press the MENU button to end processing.
• Check that no important data remains on a card before
formatting since data erased by formatting cannot be
recovered.
Removing SD memory cards
1
Check that the SD memory card access lamp is not
flashing.
2
Press the center of the SD memory card and remove
it after it bounces back by pulling it outwards.
Advertisement
Table of Contents
