Table of Contents
Advertisement
WARNING Information Display
• A warning message is displayed whenever a warning occurs.
When no warnings have been detected, "NO WARNING" is displayed.
• When multiple warnings occur, turn the search dial to check the descriptions of each warning.
If "T&S&M" is selected in setup menu No. 006 (DISPLAY SEL), a message appears in the mode display whenever a warning
or error occurs.
Monitor display
Displayed while clip information is being read or when clip configuration has
changed. No operations can be performed while this display is on the screen.
[Meaning]
BUSY
• A card has been inserted or removed.
• Updating is in progress
• Recording post processing is in progress
• Other causes
Displayed when audio voice-over cannot be recorded on a P2 card.
[Meaning]
CANNOT A.DUB
• An attempt was made to record on a card that could not be used.
• An attempt was made to record when no card was inserted
Appears in LOOP REC mode when P2 card recording is not available.
[Meaning]
• An attempt was made to record to a write protected disk.
CANNOT LOOP
• An attempt was made to record on a card with no free space available.
REC
• An attempt was made to record on a card that could not be used.
• Card status changed during recording.
• Recording was attempted when the unit was BUSY.
Displayed when playback was interrupted due to a clip error or other factor.
[Meaning]
• An attempt was made to play a clip when no clips were present.
CANNOT PLAY
• An attempt was made to play back a card that cannot be used
• The card could not be played back or playback stopped for some other reason
• Playback was attempted when the unit was BUSY.
Displayed when data cannot be recorded on a P2 card.
[Meaning]
• An attempt was made to record to a write protected disk.
• An attempt was made to record data on a card with no more free memory space
CANNOT REC
on it.
• An attempt was made to record on a card with no free space available.
• Card status changed during recording.
• Recording was attempted when the unit was BUSY.
• VFR recording started but no active frame data was input.
Displayed when a memory card is protected, there is not enough space or
CANNOT REC SD
recording in PH/HA mode is not available.
(When an AJ-YCX250G AVCHD codec board (optional) is installed.)
Displayed when a non-compatible SD memory card, non-standard management
CHECK SD
information or mismatched thumbnail data was recognized.
(When an AJ-YCX250G AVCHD codec board (optional) is installed.)
This indication appears when playback operations other than PLAY, JOG STILL,
FTP ON
VAR0.0 or SHTL0.0 are not available during FTP login.
Displayed for the first two seconds when the REC button is pressed to enter the
INT SG
EE mode and the INPUT SELECT VIDEO button or the INPUT SELECT AUDIO
button is set to SG.
INVALID IN/OUT
Displayed when an attempt was made to set an IN or OUT point in a location
POINT
where such points cannot be set.
208
For Long and Trouble-Free Operation: Error Messages
Description
Deck operation
Counter display
Operation
BUSY
continues
Operation
CANTADUB
continues
STOP
CANTLREC
STOP
CANTPLAY
STOP
CANT REC
Operation
CANT REC
continues
Operation
CHK SD
continues
Operation
Counter indication
continues
Operation
INT SG
continues
Operation
Counter value
continues
Advertisement
Table of Contents
