6
Temporarily connect a USB cable between the computer on the wireless network and the printer.
Note: After the printer is configured, the software will instruct you to disconnect the temporary USB cable so
you can print wirelessly.
7
Follow the instructions on the computer screen.
8
To allow other computers on the wireless network to use the wireless printer, follow steps 2 through 6 and step
8 for each computer.
Installing the printer on a wireless network (Macintosh)
Make sure to disconnect the Ethernet cable when installing the printer on a wireless network.
Prepare to configure the printer
1
Connect the power cable to the printer and then to a properly grounded electrical outlet, and then turn the printer
on.
1
2
Locate the printer MAC address.
a
From the home screen, navigate to:
> Reports > Network Setup Page
b
In the Standard Network Card section, look for UAA (MAC).
Note: You will need this information later.
2
Additional printer setup
44