Step 9. Setting Up Attached Devices; Step 10. Updating The Device Records; Step 11. Attaching External Devices - IBM eServer p Series Installation Manual

Step 9. Setting Up Attached Devices

Note: During the setup of each device, connect only the device end of the signal cable.
Connect the ASCII terminal to serial port 1 (S1). Connect the keyboard (K), mouse (M),
and graphics display (if available). Refer to the following figure for the locations of the
connectors.
Ethernet

Step 10. Updating the Device Records

Update the "System Records" in Appendix D, "System Records" on page 47 to reflect
the configuration of the system adapters and devices that are installed.

Step 11. Attaching External Devices

External devices used with the system are connected to connectors on the I/O drawers
or to adapters that are installed in any of the I/O drawers. Attach any external devices
now.
Do not connect the device signal cables to the rack now.
Do the setup procedures in the documentation provided for each device being
attached to the rack. Then return to "Step 10. Updating the Device Records".
2 3 4 5
1
SCSI
6 8 9
7 P1 10 11
Parallel K M S1
Chapter 1. Setting Up the System
12 13 14
17