5-2.2 Windows 95/98 - SOLTEK KT400-R Manual

KT400-R / KT400-RL
5-2.1-3 Confirming Windows 2000 Installation
1. From Windows 2000, open the Control Panel from " My Computer"
followed by the System icon.
2. Choose the "Hardware" tab, then click the "Device Manager" tab.
3. Click the "+" in front of "SCSI & RAID Controllers hardware type." The
driver "Win2000 Promise FastTrak/FastTrak 376 Controller" should
appear, informing user that the controller driver is already installed.

5-2.2 Windows 95/98

5-2.2-1 Installing Drivers During Windows 95/98 Installation
The following three sections detail the installation of the FastTrak 376 driv-
ers while installing Windows 95/98 (with the FastTrak 376 controller card
already in place). If you're installing the FastTrak 376 drivers on a sys-
tem with Windows 95/98 already installed, see "Installing Drivers with
Existing Windows 95/98".
5-2.2-2 Windows 98
1. Connect your hard drive(s) for RAID Array to IDE3/SATA1/SATA2,
and enable FastTrak 376 Controller in BIOS. Configure the hard
drive(s), partition and format your hard driver(s).
2. Install Windows 98 normally.
3. After installation, go to "Start" menu and choose "Settings."
4. Form the "Settings" menu, choose "Control Panel."
5. In the "Controller Panel" window, double-click on the "System" icon.
6. In the "System" window, choose the "Device Manager" tab.
7. In the hierarchical display under "Other Devices" is a listing for "PCI
RAID Controller." Choose it and then press the "Properties" button.
8. Choose the "Driver" tab in the "Properties" window, choose "Update
Driver," and then press "Next."
9. Choose "Search for a better driver than the one your device is using
now (recommended), "then press "Next".
10. Choose "Specify Location," and then type "A:\WIN95-98" in the text box.
96