Table of Contents
Advertisement
SPEClAL TOOLS
- 1
ClRCLlPS
1. All circlips should be inspected carefully be-
fore reassembly. Always replace piston pin
clips after one use. Replace distorted circlips.
When installing a circlip
@,
make sure that
the sharp edged corner
@
is positioned op-
posite to the thrust
@
it receives. See the
sectional view.
@ I
Shaft
SPECIAL TOOLS
The proper special tools are necessary for com-
plete and accurate tune-up and assembly. Using
the correct special tool will help prevent damage
caused by the use of improper tools or improvised
techniques.
FOR TUNE UP
1. Inductive Timing Light
PIN. YM-33277
This tool is necessary for adjusting ignition timing.
2. Fuel Level Gauge
P I N . YM-01312
This gauge is used to measure the fuel level in
the float chamber.
1-4
Advertisement
Table of Contents
Troubleshooting
