Checking Hydraulic Tank Oil Level; Checking Transmission Fluid Level - Kubota RTV1140 CPX Operator's Manual

48 PERIODIC SERVICE
BChecking Hydraulic Tank Oil Level
1. Park the vehicle on a flat surface.
2. Stop the engine and remove the key.
3. Tilt the seat.
(See "HOW TO OPEN THE HOOD AND SEAT" in
"PERIODIC SERVICE" section.)
4. To check the oil level, remove the dipstick, wipe it
clean, screw it into filling hole and remove dipstick
again.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
(1) Filling plug with dipstick
A If oil level is low, do not run engine.
(A) Oil level is acceptable within
this range
BChecking Transmission Fluid Level
1. Park the vehicle on a flat surface, raise the cargo bed,
mount the safety support and shut off engine.
2. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
(1) Oil inlet (A) Oil level is acceptable within this range.
(2) Dipstick
A If oil level is low, do not run engine.