Mounting the Extruder Set
1. Lay the extruder set on top of the
extruder seat with the two extruder
fans facing the front.
2. Secure the extruder set onto the
extruder seat by using two M3x12
from the bottom up.
3. Install the side fan duct. To do this,
find the side fan duct and attach it onto
the left side of the extruder set. Secure
it with the supplied M3x8 screw.
Tip:
place the M3x12 screw through
the mounting hole of the extruder seat
first. Afterwards, align the extruder set
and tighten.
Dreamer User Guide |
www.ff3dp.com
16