Hardware Assembly - Flashforge Dreamer User Manual

C.

Hardware Assembly

The Dreamer comes pre-assembled and is almost ready-to-print (ARP).
All you need to do is set the appropriate voltage, mount the extruder set,
and install the filament. It will only take between 5 to 10 minutes before
you can fire up the Dreamer and prepare for your first 3D print!
PRECAUTION:
FlashForge Dreamer uses a switching power supply with 115V/230V.
Prior to installing the hardware, it is critical to check the AC output
voltage of your home or workplace. The power supply should be
switched to reflect your AC output voltage. Failure to do so will cause
severe damage to the Dreamer. Please follow the steps below to switch to
the correct voltage.
For the United States and Canada, the correct voltage to use is 115V.
For most European countries, use 230V.
FLASHFORGE will not be responsible for damages as a result of
improper care.
Dreamer User Guide | www.ff3dp.com
Please double-check as
15