Flashforge Dreamer User Manual page 33

· Jog Mode: Select from the drop down menu for increment of
each move.
· Center X: Same as "Homing X."
· Center Y: Same as "Homing Y."
· Center Z: Same as "Homing Z."
· Make Current Position Zero: Set the current position of the
extruders and the platform as (0, 0, 0). (NOTE: X, Y, and Z boxes
are for display purposes. Changing the value in the boxes will
not affect anything.)
· X/Y Speed: Controls how fast the extruders will move when
performing the above movements.
· Z Speed: Controls how fast the platform will move when
performing the above movements.
· End-Stop Switch
· X Maximum Status: Displays "Open" when the extruder is not
at the maximum X position. Displays "Triggered" when the
extruder reaches the maximum x position.
· Y Maximum Status: Displays "Open" when the extruder is not
at the maximum Y position. Displays "Triggered" when the
extruder reaches the maximum Y position.
· Z Minimum Status: Displays "Open" when the extruder is not
at the minimum z position. Displays "Triggered" when the
extruder reaches the minimum Z position.
· Fan Controls
· Open: Turn on the side fan located at the left of the extruders.
· Close: Turn off the side fan located at the left of the extruders.
· Stepper Motor Controls
· Enable: Unlock the motor to be controlled manually.
· Disable: Lock the motor so it does not allow any movement.
· LED Color: Change the LED color of the Dreamer.
Dreamer User Guide | www.ff3dp.com
33