Change Extruder; Maintain - Flashforge Adventurer 4 Pro User Manual

6.4.4 Change Extruder

After installing a new nozzle, please set the compensation value according to the
temperature the new nozzle adopts to; the actual deviation range of the extruder: -10 ~
30. Click [Next] to enter the extruder selection interface. Select the new nozzle to be
installed and the maximum temperature during preheating will be set according to the
selected nozzle. Please ensure that the installed nozzle is the same as the selected nozzle
type, and click [Complete] to return to the maintenance interface.
If a different nozzle is replaced, the default maximum temperature of
Note
preheating will change to the temperature of the new nozzle.

6.4.5 Maintain

In case of errors or unclear operation, please check and operate according to the
maintenance suggestions first.
24