Flashforge Dreamer User Manual page 11

4.The Dreamer will have an accessory
box on top of it, which will house the
extruder set. Remove the box and the
foam pad from the Dreamer, and
gently lay the extruder set on the
Dreamer build plate.
Inside the accessory box, you will find
a roll of 3M Blue Painter's tape, an
SD card, a side fan duct, and four
pieces of removable side panels.
5.Hold the sides of the build plate as
shown in the illustration, and lift up
slowly until it is at the top.
11
Dreamer User Guide | www.ff3dp.com