Equipment Configuration And Operation; Dual-Extruder Printing Mode Setting - Flashforge Creator 3 Pro User Manual

5. Equipment Configuration and Operation

5.1 Dual-extruder Printing Mode Setting

When printing dual-color/dual-filament models in thre dual-extruder printing mode, please make sure the
nozzles are in contact with the anti-oozing plate. This will prevent the nozzles from overflowing during the
printing process.
Creator 3 Pro defaults to the left extruder as the filament supporting extruder and the right extruder as the
printing extruder. When printing a single-color model, the right extruder is automatically used as the printing
extruder if not set by the user. The following modes can be set for printing:
In the expert mode:
1. Load the model;
2. Select the support type, and click ;
3. Add the support automatically, and click [Supports] > [Auto Supports];
4. Click [Start Slicing], entering the parameter configuration screen;
5. Select the configured filament, such as Creator 3 Pro PLA + PVA;
6. Click [Slice].
16