Flashforge Dreamer User Manual page 30

· Material Left: Choose the material that will be used for the left
extruder.
· Supports: Enable/disable support for the object.
overhang usually requires support to print successfully.)
· Resolution: Presets values for layer thickness, infill, and speed.
These values can be modified at "More Options."
· Wall
(Available for Slic3r)
same height.
· Raft
(Available for Skeinforge)
· Skirt: Builds a single layer wall/outline around the object.
· More Options:
· Layers
· Layer Height: Smaller number means higher resolution.
typical values are between 0.1 and 0.5 (100 to 500 microns).
Use 0.5 for fast prototypes and 0.1 for fine details.
· First Layer Height (Available for Slic3r): Enter the layer
height of the first layer. A small value of layer height requires a
more precise leveling in order for the filament to stick.
Sometimes it is difficult to accomplish. By adjusting the first
layer height, it allows user to print a fine object with a higher
success rate.
· Number of Shells: Enter the number of layers that surrounding
the object. Typical values are between 1 and 5.
· Infill
· Fill Density: Enter the density value of the object. 0% means
completely hollow and 100% means completely solid. Typical
values are between 3% and 50%.
· Fill Pattern: Select the pattern for printing the infill. Available
patterns are line, rectangle, and hexagon.
Dreamer User Guide |
: Builds a wall around the object with the
: Builds a raft under the 3D object.
www.ff3dp.com
(Note: Excessive
30