Compaq AlphaServer GS60E Installation Manual page 31

Use the following procedure to unpack the system cabinet:
Position the carton so that the front door faces an open space with enough
clearance to allow the cabinet to be rolled down ramps.
Using a utility knife, cut the shipping straps from the carton.
Remove the outside top cardboard cover.
Remove the outside shipping box, using a 7/16" socket wrench to remove the
four bolts that hold the box together.
Remove the four corrugated spacers and the ramp and accessories boxes
from around the cabinet.
Remove the inner protective plastic wrapping by slipping it up and over the
cabinet.
Locate the box that contains the ramp kit and open it (see Figure 3-2).
Follow the unpacking illustrations located on the outside of the shipping box
for removing the cabinet from the pallet (see Section 3.4).
NOTE: It's a good idea to save all packing materials intact in case the system
needs to be shipped in the future.
Installing the System Cabinet 3-7