Turn The Power On And Check Indicators; Control Panel - Compaq AlphaServer GS60E Installation Manual

6.3

Turn the Power On and Check Indicators

Power up the system by pushing up the circuit breaker handle on the
AC input box. Turn the keyswitch to the On position and then push the
On/Off button under the front cover. Monitor the state of the system as
it powers up.
Figure 6–3 Control Panel
1
Turn the power on by pushing the circuit breaker handle up (see Figure 6-1).
1. Go to the front of the cabinet and check that the power supply VAUX LEDs
are on (see Figure 6-4).
2. Turn the control panel keyswitch to the On position.
3. Open the control panel front cover and press the On/Off pushbutton.
4. Monitor the state of the system (see LEDs in Figure 6-3) as it powers up.
NOTE: With the keyswitch in the On position, if all six LEDs are blinking, one
or more of the power supplies has failed or a power supply is missing.
With the keyswitch in the Off position, the LEDs will also blink but do
not provide power supply status.
6-6 AlphaServer GS60E Installation Guide
2 3
10
8
6
9
5 7
4
GS60E63-99