red to show that the timer function (with the
last programmed settings, for both Space and
Water Heater) has been activated.
Operating the Pump
The Whale Watermaster® Exterior Pump
works on a pressurised system. This means it
will pump up the system until working pressure
is reached and then switch itself off. When
the pressure drops when a tap is opened, the
pump will start to run and will continue to run
until the pressure builds up again after the tap
is closed.
On the iVan Control Panel you can see if the
pump is running by checking the pump icon.
• Blue icon with a grey bar indicates that the
pump has been isolated.
• Red icon with a grey bar indicates that
pump is turned on but not running.
• Red icon with a red bar indicates that the
pump is turned on and running.
Options
There are a number of additional user options
that can be adjusted as required.
Menu
Functions
Beep
Enables user to
turn the keypad
tone on/off
Flashing
Enables user to
Light
turn the home
button flashing
on/off
Mains
Enables user
Supply
to set the
maximum power
consumption
as determined
by the level of
mains electric
supplied. This
function is
used to avoid
excessive
consumption
tripping the
system
Brightness
Water
Heater
Boost Time
Screen Off
Ava i l a b l e
Settings
To enter the options menu from the home
On/Off
screen, touch the spanner icon and then the
options icon. Scroll through the available
options (see table) using the arrow keys, and
On/Off
select the desired setting using the + and -
buttons.
Troubleshooting
iVan is equipped with an electronic diagnostic
Select
system which will detect fault conditions
between
ranging from poor gas or DC supply to internal
1 and 16
heater malfunctions. In the unlikely event of a
amps
failure, an error message will appear with a tap
icon to indicate there is a problem with the
Water Heater, or a van icon to indicate a fault
on the Space Heater. Follow the instructions
as outlined below.
Space Heater Diagnostic Screens
Check gas supply
Enables user
Dim/
to adjust
Low Dim/
the screen
Low
brightness
Bright/
Bright
Enables user
15 mins/
to change the
30 mins/
water heater
60 mins/
boost timer
forever
duration
Enables the
3 mins/ 5
user to select
mins/ 10
the time before
mins/ 15
iVan goes
mins
into sleep
mode, where
NB 3
all settings
mins is
remain active
economy.
but the screen
is turned off.
The screen can
be reactivated
at any time by
pressing the
home button
53