Whale Submersible Pump - Bailey ADVANCE 2019 Owner's Manual

36
t r
o emove the
1. Disconnect the Whale Aquasource from
the tap.
2. Lift the lid of the socket to the vertical
position.
3. Depress the two white location buttons on
the Whale Watermaster plug and remove
from the socket.
4. Close the lid of the socket.
5. Stow away the in a clean, chemical-free
area.
When you are using the Aquasource
system it is important that you do not
leave the vehicle unattended without
turning the water source off at the
supply point.
w a
hale quaSource
W S p
hale ubmerSIble ump
The Whale Submersible pump is designed to
run when fully submerged in water. It pumps
water from an aqua roll container to the fresh
water tank. 2.5 aqua rolls will fill the tank.
t w
o inStall the hale
1. Fill a suitable water container and place
it below the Whale Watermaster socket
(located on the outside wall of the
motorhome).
2. Place the Whale submersible pump into
the water container. The pump should
reach the bottom of the container.
3. Lift the lid of the external Whale
Watermaster socket.
4. Insert the plug (opposite end to the pump)
firmly into the socket and close the lid to
locate and lock the pump plug into place.
5. When the control panel switch is on the
pump will automatically pump water into
the fresh water tank.
6. When the on-board tank is full the pump
will turn off.
7. To remove the Whale submersible pump,
lift the lid of the Whale Watermaster
socket into the vertical position.
8. Remove the Whale submersible pump plug
from the Whale Watermaster socket.
9. Close the lid of the Whale Watermaster
socket.
When the water container is empty
the pump will continue to run.
The maximum continuous operation
should not exceed 15 minutes.
S p
uBmerSiBle ump