Function Description; Winter Operation; Summer Operation; Operating Instructions - Bailey Pursuit Owner's Manual

Function Description

The liquid gas heater Combi E is a warm-
air heater with integrated hot water boiler
(10 litres volume). The burner operates
fan supported, which ensures trouble-free
function even when on the move. The unit also
has heating elements for electrical operation.
In winter operation the heater can be used
to heat the room and simultaneously warm
water. If only warm water is required, select
summer operation.

Winter Operation

In winter operation, the unit automatically
selects the required power setting according
to the temperature difference between the
temperature set on the control panel and the
current room temperature. When the boiler
is filled the water is automatically heated as
well. The water temperature depends on the
selected operational mode and the heater
output.
All 3 energy selection options can be used for
winter deployment.
With gas operation the unit automatically
selects the output level that is required.
Depending on the fuse protection at the
camping site, power of 900w (3.9A) or 1800w
(7.8A) can be manually selected for electrical
operation.
If more output is required (e.g. heating up
or low outside temperatures) gas or mixed
operation should be selected so that enough
heating power is always available.
With mixed operation, 230v electrical operation
is preferred if the power requirement is low
(e.g. for maintaining the room temperature).
The gas burner is not enabled until the power
requirement is higher and is the first to switch
off during heat-up operations.
Summer Operation (boiler operation only)
Gas operation or 230v electrical operation
is used for hot water preparation. The water
temperature can be set at 40°C or 60°C.
• With gas operation the water is heated
at the lowest burner setting. Once the
water temperature is reached the burner
switches off.
• Depending on the fuse protection at the
camping site, power of 900W (3.9 A) or
1800W (7.8A) can be manually selected for
electrical operation.
Mixed operation is not possible. With
i
this setting the unit automatically
selects electrical operation. The gas
burner is not enabled.
Repairs may only be carried out by an
!
expert.

Operating Instructions

Always observe the operating instructions and
"Important operating notes" prior to starting!
The vehicle owner is responsible for the
correct operation of the appliance.
The installer or vehicle owner must apply the
yellow sticker with warning information, which
is enclosed with the appliance, to a place in
the vehicle where it is clearly visible to all
users (e.g. on the wardrobe door) Ask Truma
to send you stickers if necessary.
Before using for the first time it is essential to
flush the entire water supply system through
with clean water. If the heater is not being
used, always drain the water contents if there
is a risk of frost. There shall be no claims
under guarantee for damage caused by frost.
Materials in the device which come into
contact with water are suitable for use with
drinking water (see manufacturer declaration:
www.truma.com – Manufacturer Declaration).

Room Thermostat

To measure the room temperature, an external
room temperature sensor (s) is located in the
vehicle by the control panel.
S = Room temperature sensor
The thermostat setting on the control panel (1–
5) must be determined individually depending
on the heating requirement and the type of
vehicle. For an average room temperature of
about 23 degrees we recommend a thermostat
setting of about 4.
75