Defrosting; Winter Operation; Troubleshooting - Bailey Pursuit Owner's Manual

118
of mildew.
If the refrigerator is to be taken out of service
for an extended period of time, close the on-
board shut-off valve and the cylinder valve.

Defrosting

As time goes by, frost builds up on the fins
inside the refrigerator. A layer of frost thicker
on one side may occur and does not represent
a malfunction. When this layer of frost is
about 3mm thick, the refrigerator should be
defrosted.
Switch off the regulator, as described in
section "Shutting off the refrigerator".
Remove all food and the ice cube tray.
Leave the refrigerator door open to allow air
to enter and prevent formation of mildew.
After defrosting
and fins free of frost), wipe both cooling
compartments with a cloth.
Water thawing in the main compartment of the
refrigerator runs into an appropriate container
at the back of the refrigerator. From there the
water evaporates.
The layer of ice must never be
removed forcibly, nor may defrosting
be accelerated using a heat source!

Winter Operation

In winter, check that the ventilation
grilles and the exhaust duct system (1)
have not been blocked by snow,
leaves, etc.
Information on failure display and trouble-
shooting.
If a malfunction occurs, the indicator
LED "Failure" (1) flashes and LED (2)
simultaneously. If the failure is not resolved,
it repeats after 1 hour.
Status messages on the display.
LED is flashing
230v mode: "230v" is not available or voltage
is too low
LED is flashing
12v mode: "12v" is not available or voltage is
too low.
(freezer compartment
LED is flashing
Gas/Auto mode: Flame not ignited.
All temperature setting LEDs are flashing
Temperature sensor defective, refrigerator
works on mid temperature setting.
LED + all temperature setting LEDs are
flashing
230v- Heating element defective.
LED + all temperature setting LEDs
are flashing
12v- Heating element defective.

Troubleshooting

Before notifying the authorised
i
Service Centre, please check whether:
• The instructions in the section
"Operating the refrigerator" have
been followed.
• The refrigerator is level.
• It is possible to operate the
refrigerator with any available power
source.
Failure: The refrigerator does not cool
sufficiently.
Possible cause and action you can take
q)Inadequate ventilation to the unit.
a) Check that the ventilation grilles are not
covered.
q) Thermostat setting is too low.
a) Set thermostat to a higher level.
q) The condenser is heavily frosted.
a) Check that the refrigerator door closes
properly.
q)Too much warm
stored
a) Allow warm food to cool down before
storage.
q) Has the appliance only been running for a
food has been