Standby Screen; Main Menu - Bailey Pursuit Owner's Manual

1. Both the control panel and boiler are off.
2. To start the system, press the Power button
on the control panel. The Splash Screen is
displayed and green LED is lit. The boiler will
now start with the previously saved settings
(factory settings by default).
The system will now be drawing variable 0.2–
1A of current from the 12v supply.

Standby Screen

The Standby Screen is displayed after the
Splash Screen. This screen contains useful
information about the status of your heating
system.
NB: If Standby Screen is set to "Dark" in
Backlight settings, the Standby Screen will not
be displayed; the screen will be dark unless
touched.
A. C lock is enabled. Day of the week and time
shown.
B. Outdoor temperature. [Optional outdoor
temperature sensor required.]
C. Room temperature. Measured at the control
panel. [Optional discrete room temperature
sensors available.]
D. Central heating circulation pump is active.
E. Delayed Start/Cycle is enabled.
F. Day Mode active.
G. Gas Cylinder Status. Full/empty and
active EisEx shown. [Additional accessories
required.]
H. N ight Mode active.
I. 230 V supply. If not displayed, the boiler is
not receiving 230 V supply.
J. Power button. Press to switch system on
and off. Lit green LED indicates system is on.
K. MENU button.
L. Press to access Main Menu from Standby
Screen or Settings Menu.

Main Menu

Press MENU button to access the Main Menu
from the Standby Screen or Settings Menu.
The screen will revert to the Standby Screen
after 30 secs if untouched.
1. Standby Screen. Press MENU button.
2. Main Menu.
a. What's Activated Menu. [Not displayed if no
activated functions are detected.]
b. Settings Menu.
71