Start/Standby Screen; Switch On/Return To Setting Level; Switch Off; Change The Room Temperature - Bailey Pursuit Owner's Manual

84

Start/standby screen

After connecting the control panel to the
power supply, a start screen is shown after a
few seconds.
If no entry is made within a few minutes, the
standby screen is automatically shown again.
The display shows the time and correct room
temperature alternately.

Switch on/return to setting level

• Press the control knob/push button for
longer than 3 seconds or the back button.
The display shows the setting level. The first
symbol flashes.
Previously set values/operating
i
parameters become active again after
the system is switched on.

Switch off

• Press the control knob/push button for
longer than 3 seconds.

Change the room temperature

• Use the control knob/push button to select
the symbol in menu line (3).
• Click to change to the setting level.
• Depending on the connected device, use
the control knob/push button to select
between the heater or air conditioning unit.
• Use the control knob/push button to select
the required temperature.
• Click the control knob/push button to
confirm the value.
Heater
Settable temperature range 5°C–30°C (1°C
steps)
a = heater * - Heater is switched on.
* This symbol will flash until the required room
temperature is reached.

Change the warm water level

• Use the control knob/push button to select
the symbol in menu line (3).
• Click to change to the setting level.
• Use the control knob/push button to select
the required level.
• Click the control knob/push button to
confirm the value.
a = Boiler *
- Warm water boiler is switched on.
b = 40°
- Warm water temperature 40°C.
c = 60°C
- Warm water temperature 60°C.
d = boost *
- Targeted, fast heating of the content
of the boiler (boiler priority). The water
temperature is kept at the higher level
(around 62°C) – Not Combi Diesel.